drv8840老是出现ocp问题请教

Other Parts Discussed in Thread: DRV8840

   drv8840老是出现ocp问题请教。drv8840运行几秒或者其它秒之后,fault引脚出现0电平,且不可回复,看资料应该是出现ocp保护。另外一种板子外围参数一样,负载也是一样,基本不出现这个ocp。

请教下,drv8840的ocp出现的原理是咋回事?在drv8840的资料上,没有看到ocp相关的是详细说明

  • An analog current limit circuit on each FET limits the current through the FET by removing the gate drive. If this analog current limit persists for longer than the OCP time, all FETs in the H-bridge will be disabled and the nFAULT pin will be driven low. The device will remain disabled until either nRESET pin is applied, or VM is removed and re-applied.

    你可以从PCB layout的区别上看是否有过电流情况发生。

  • PCB layout,基本一样,这个板子是从那个能用的板子抄过来的(包括布线)。不过一直还在找差异,一个板子上两个芯片,驱动步进电机。每次ocp事件都是同一个芯片
  • 通过这几天的实验,不是pcb问题。将不出现ocp芯片的焊接到出现ocp位置,则不出现ocp;将出现ocp的芯片焊接到之前不出现那ocp的位置,继续出现ocp,初步判断是芯片差异引起的。
    现在我 Ichop设计4A的,4*1.414 = 5.656A,和Iocp的6A还差一点。在同一位置,有的出现有的不出现ocp现象,是您们芯片工艺引起的不一致性,还是其它问题?,希望能给个提示及其相关回答,谢谢