CC1310，ADC管脚映射问题

要用IOID_24管脚测到电压，直接去修改continuousConversion.adcChannel = Board_ADCBUF0CHANNEL0;為continuousConversion.adcChannel = Board_ADCBUF0CHANNEL1;就可以了

我的板子型号是4+4的CC1310F128RSM，想把ADC口映射到IOID_8口，在CC1310_LAUNCHXL.h中做了如下修改：
/* Analog capable DIOs */
#define CC1310_LAUNCHXL_DIO23_ANALOG IOID_8//IOID_23
#define CC1310_LAUNCHXL_DIO24_ANALOG PIN_UNASSIGNED//IOID_24
#define CC1310_LAUNCHXL_DIO25_ANALOG PIN_UNASSIGNED//IOID_25
#define CC1310_LAUNCHXL_DIO26_ANALOG PIN_UNASSIGNED//IOID_26
#define CC1310_LAUNCHXL_DIO27_ANALOG PIN_UNASSIGNED//IOID_27
#define CC1310_LAUNCHXL_DIO28_ANALOG PIN_UNASSIGNED//IOID_28
#define CC1310_LAUNCHXL_DIO29_ANALOG PIN_UNASSIGNED//IOID_29
#define CC1310_LAUNCHXL_DIO30_ANALOG PIN_UNASSIGNED//IOID_30
但是IOID_8还是测不到电压值，这是为什么呢？

/* SPI Board */
#define CC1310_LAUNCHXL_SPI0_MISO IOID_8 /* RF1.20 */
#define CC1310_LAUNCHXL_SPI0_MOSI IOID_9 /* RF1.18 */
#define CC1310_LAUNCHXL_SPI0_CLK IOID_10 /* RF1.16 */

修改 IDIO8为PIN_UNASSIGNED

好的，已经解决了，谢谢