Other Parts Discussed in Thread: UNIFLASH, IWR1443
I have just started to use the IWR1443BOOST. I am encountering a few issues while running the demo in the SDK(version 2.1).
I have tried to follow the steps listed in the mmWave SDK User Guide. Listed below are the steps i have completed.
- Set the SOP config to 101 and power cycle the board
- Upload the image xwr14xx_mmw_demo_mss.bin . Set the COM port to the UART data port
- On flashing these images, it gives a successfully completed message in the console.(The version of Uniflash is 8.2)
- Set the SOP config to 001 and power cycle the board
- Using the mmWave gallery (https://dev.ti.com/gallery/view/mmwave/mmWave_Demo_Visualizer/ver/2.1.0/).
- Press the "Send Config to Device" button in the Visualizer
- The Console Messages window as shown below
However,after Switching to the Plots tab, I can not see the plots.
What could be the mistake in the procedure that I am following?