关于BL-PFC连接的问题

user1641047

Other Parts Discussed in Thread: CONTROLSUITE

您好，我购买了一套bl-pfc开发套件，我安装的是CCS6，下载BL-PFC程序正常，连接时一直连接不上，请问CCXML文件中connextion中仿真器选择是不是Texas Instruments XDS 100V1 USB Emulator，目标板是不是选择 Experimenter,s kit - piccolo f28035呢？

4 年多前

0 Green Deng 4 年多前

TI__Guru** 101655 points

请问你使用的是这款套件吗？www.ti.com/.../TIDM-BLPFC
如果是的话可以参考以下文档中的说明Setting up the Hardware ：C:/ti/controlSUITE/development_kits/BLPFC_v1.0/Docs/QSG-BLPFC-GUI_Rev1.2.pdf
上述文档是用来运行GUI所需的硬件配置，配置完之后也可以运行官方例程。其中，仿真器一般配置为XDS 100V2，目标板可以是Experimenter's kit - piccolo f28035。

0 Green Deng 4 年多前

TI__Guru** 101655 points

另外，这款套件的所有软硬件设计资料和文档都可以在以下目录中找到：C:\ti\controlSUITE\development_kits\BLPFC_v1.0

0 user1641047 4 年多前回复 Green Deng

Intellectual 280 points

谢谢，是这套软件，但是我仿真器配置成XDS 100v2 连接仿真器都是失败。j6也短接了，还能有什么问题呢？

0 Green Deng 4 年多前回复 user1641047

TI__Guru** 101655 points

按照使用说明上写的：
Connect USB connector to the Piccolo (CC2803x) controller card for emulation. Use an external +12Vdc supply at JP1 to power up all the control circuit for now. By default, Piccolo controller is enabled to boot from FLASH and run the BLPFC code. The user should not use the RAM to program or run the BLPFC code. Turn on the switch SW1 by placing it towards the electrolytic caps (C5, C6 and C7). This will apply the external +12V supply to the BL PFC board.
Use an appropriate isolated AC power supply (100Vac to 250Vac, 47Hz~63Hz, 350W min) to provide input power to the BLPFC EVM. Connect the ac supply to the BLPFC EVM but do not turn on the AC power at this time. Connect an appropriate resistive load (only) to the BLPFC DC output terminals (PFC-Out & GND terminals). Resistive loads within the range of 10W ~ 300W are recommended. Do not use electronic load with this board.
其中没有提到J6，由于我这边没有这款套件，没办法帮你测试，也不清楚上面器件的具体位置，还是得需要你根据文档要求进行实验