Part Number: TMS320F28035 How do I make the DSP28035 (or any other model) get a three-way Hall signal?
The DSP28035 Ecap input port is only 1, and the single brushless motor Hall signal output line has three, how should it be connected?
I want to use…
Hi Yale:
我回复一下Joseph的问题,麻烦跟进一下,谢谢!
1) As shown in Figure 1 below, the customer's voltage reference circuit, VDDA is 5V, and 3.3V is generated through the voltage regulato
Is VDDA supply and VDDIO supply generated from the same regulator? When these…
Part Number: MSP430FR5994
If I use the data collected by the ADC module that comes with the MSP430FR5994, how should I convert the data format to the array input in the example transform_ex1_fft_fixed_q15 for direct use.
Part Number: TLV320AIC3204 这是我的寄存器配置
MCLK=24.576MHZ,WCLK=3.072MHZ,BCLK=48KHZ,AIC3204处于主模式,给FPGA提供WCLK和BCLK
# 寄存器 写入数据
0x00,0x00 // Initialize to Page 0
0x01,0x01 // S/W Reset to initialize all registers
0x0b,0x81 // Power up NDAC divider with value …
Part Number: TMS320F28035 我对此并不熟悉,以下内容如有错误之处请您批评指正,如有表达不清的地方请您指正。十分感谢
I am not familiar with this, please criticize and correct if there is any mistake in the following content, and please correct if there is any unclear expression. Thank you very much…
Hello, about your questions, please refer to the below reply:
Please point them to the Application Section of the ADS8881 data sheet. We have several signal chain suggestions that are optimized for various input signal types and performance targets. What…
参考下工程师的回复:
Make sure that the PWM and ADC are configured correctly according to the hardware board you used. Check the PWM output and the voltage on the ADC input channel, and then check the related ADC result.
Please take a look at the Universal Project…
英文论坛回复:
You will need to connect pin 16 on the PGA309 (Vref) to 5V. One option is to connect Vs (Pin 3) to Vref (pin 16). However, Vs is often has drift an noise when compared to a precision voltage reference. This may be ok if you are doing a ratiometric…