Other Parts Discussed in Thread: OPA860 , DEM-OTA-SO-1A , TINA-TI 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/amplifiers-group/amplifiers/f/amplifiers-forum/1044415/opa860-opa860-i_q-setting 器件型号： OPA860 主题中讨论的其他器件…
Part Number: LM74701-Q1 Hi, TI Experts:
I am evaluating LM74701-Q1 for my project, and I tested your EVM these days.
I have several questions about this part, waiting for your reply.
1. Full conduction mode: I tested the EVM, the Voltage difference between…
Ginger 说： But the examples are to turn off EPWM after TZ1 is triggered and goes to interrupt.
Is it necessary to turn off EPWM in the interrupt function? Will interrupt delay the time, how long will it take?
After correct configurations, the output waveform…
您好，100ms您这里指的转换时间吗?OPA 3001的转换时间可以是100ms或者是800ms。
并且OPA3001 能对于来源于灯泡的50Hz或60Hz的噪声源降到最低。
The device integrates its result over either 100 ms or 800 ms, so the effects of 50-Hz and 60-Hz noise sources
from typical light bulbs are nominally reduced to a…
Other Parts Discussed in Thread: OPA860 , OPA615 , DEM-OTA-SO-1A 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/amplifiers-group/amplifiers/f/amplifiers-forum/718099/opa860-opa860-sample-hold-circuit 器件型号： OPA860 主题中讨论的其他器件…
Other Parts Discussed in Thread: DEM-OPA-SO-1A , LMH6702 上一小节从理论上分析了CFB运放负向输入端的分布电容的影响。大家可能觉得还是很空洞。下面将从实验结果来验证上面的理论。（我总是喜欢先从理论的角度分析一个问题，然后再用实验来验证。有了实验结果，会让理论更形象，也更让人记忆深刻）。
下面是工程师Michael Steffes用老的CFB运放做的实验结果。它在上一小节的输入电容的位置，分别用0.5pF和5pF的电容做的实验。当负相输入电容为5pF时…
Part Number: LMG3522R030-Q1 Hi ，everyone，I use this chip to build three-phase bridge circuit, shared 6; LMG3422R030-Q1, through the dedicated DSP microprocessor output PWM signal, so as to control its switch, the output is connected to the three-phase…
