Other Parts Discussed in Thread: LM706A0 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/tools/simulation-hardware-system-design-tools-group/sim-hw-system-design/f/simulation-hardware-system-design-tools-forum/1576912…
Part Number: OPA858 Dear Engineer,
I would like to ask a technical question regarding the OPA858DSGEVM board I purchased earlier.
At first, the board did not work when I applied a signal to the inverting input. After reviewing the schematic, I suspected…
Clarifications Needed
Before diving in, a few details from your posts would help refine this further:
When you say "driver loss," are the gate signals completely absent during portions of the cycle, or are they intermittent/degraded in amplitude…
Part Number: TPS7B63-Q1 Hi Team,
Hope all is well.
My customer is using this device.
When the input voltage (VIN) suddenly rises, the output voltage (VOUT) follows suit, reaching 5.878V. This level potentially exceeds the voltage rating of the MCU's I…
Part Number: TLV9062 Hi TI Experts,
I'm using the TLV9062 to build a difference amplifier with a designed gain of 5.1 V/V.
Setup:
V+: 5V
V-: GND (Single Supply)
Topology: Standard 4-resistor difference amplifier.
Input Signal: 1kHz Sine wave…
Part Number: DAC7612 We are facing an issue: how to quickly tell whether DAC7612U or DAC7612UB is mounted on our products. Our end customers have questioned how we can confirm that DAC7612UB, rather than DAC7612U, is used on the units. According to the…
Part Number: DAC7612 We are facing an issue: how to quickly tell whether DAC7612U or DAC7612UB is mounted on our products. Our end customers have questioned how we can confirm that DAC7612UB, rather than DAC7612U, is used on the units. According to the…
你好，能不能帮我向工程师转述以下问题，
Generally speaking, when designing a flyback switching power supply, it is usually designed according to the default input of AC85-265V. The technical documents about TI also design the flyback switching power supply according to this…
