看了下最新数据手册 A CAN network design is a series of tradeoffs, but these devices operate over wide –12-V to 12-V commonmode range. In ISO11898-2 the driver differential output is specified with a 60-Ω load (the two 120-Ω termination resistors in parallel) and…
Other Parts Discussed in Thread: OPA1679 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/audio-group/audio/f/audio-forum/1009760/opa1679-reference-design-for-single-end-audio-input-to-differencial-audio-output 器件型号…
这个引脚在datasheet上有这样说明：
Emulator pin 1. When TRST is driven high, this pin is used as an interrupt to or from the emulator system and is defined as input/output through the JTAG scan. This pin is also used to put the device into boundary-scan mode. With…
Other Parts Discussed in Thread: UCC2897A 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1007828/ucc2897a-we-are-looking-to-design-the-isolated-dc…
Part Number: LMR16030 请问输出电容能否使用22uF贴片电容+100nF贴片电容+220uF插件电解电容？
Can we use 22uF CHIP CAP+100nF CHIP CAP+220uF DIP E.CAP for the output capactitances of LMR16030?
rctan@computime.com
1, In datasheet of LMR16030，the output capactitance is recommended as…
