Other Parts Discussed in Thread: PMP23464 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1606913/ucc25660x-calc-pmp23464-design-battery-charger-with…
Part Number: DAC38RF82
Hi!
We have planned to use the DAC38RF82 In our design with below configuration.
Fsample : 8400MHz
Fout : 275-475MHz (Bw:200MHz) in both channels
Interpolation : 6x
NCO : 375MHz
Throughput/lane : 7000MSPS(L=8…
Other Parts Discussed in Thread: WEBENCH-CIRCUIT-DESIGNER , LM5143A-Q1 , LM5143DESIGN-CALC 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1592529/webench…
Part Number: LM359 Subject: Inquiry Regarding Using LM359 as a Voltage Follower
Dear TI Support,
I’m considering using the LM359 op-amp in a voltage follower (unity gain buffer) configuration.
My application involves a single-supply system with V…
Part Number: PMP41009 Other Parts Discussed in Thread: UCC28740 , Hello, I am debugging a self-designed flyback switching power supply with an input of 90-900VAC and an output of 24VDC. I use the UCC28740 chip and adopt the relevant power supply circuit…
Part Number: TPS552882 输入电压：12V，输出电压：19V/4.5A。单板的12V输入电源插入后，19V转5V的DC-DC先工作（电流不超过0.1A），然后通过按轻触开关接入MCU通过使能信号控制Jetson模组（19V供电）和其他DC-DC（19V输入）上电。通常几次上下电后（不是第一次上电就会坏），在按轻触开关使能Jetson模组（19V，电流不超过2A）和其他DC-DC上电（19V，电流不超过1A）的过程中，TPS552882RPMR DC-DC模块烧坏，大部分会发出滋滋的声音且模块发热…
Thank you for sharing the schematic.
From my understanding of the circuit the initial issue it that the input signal is bipolar where the ADS1119 is not designed to measure that signal. This is due to the analog input going below AGND. Please see Section…
Part Number: TPS6594-Q1
We use the single SOC solution (TDA4APE6), and use the PMIC TPS6594133ARWERQ1.
According to the EVM configuration document Powering Jacinto 7 SoC For Isolated Power Groups With TPS6594133A-Q1 + Dual HCPS (Rev. A)
GPIO9 of TPS6594133…
