Part Number: TPS56836 Input range 12V~24V
Output Fix 3.3V(Standby mode ) / Io max = 4.7A
使用在12V input時,電源插入時,TPS56836 power ic 冒煙燒毀,此時未開機.
是否Ti可作分析並說明燒毀的的原因及燒毀的Pin腳位置?
tps56836 information.pdf
Hello, the output power is 40W, and it does not need to comply with the AEC-Q100 standard. I want to build a high-voltage, wide-range input flyback switching power supply with a dual-switch cascaded structure like PMP41009. Do you have any good chip recommendations…
Part Number: LM3410-Q1 Other Parts Discussed in Thread: LM3410
Our company is currently utilizing your LM3410 IC in a T-BOX project, where it functions as a charging IC for a backup 0.1C NiMH battery with 600mAh capacity. The input power is a stable 5V…
We are using the ACF2101 to detect the current from a photodiode (Hamamatsu S1336-8BQ). In our application, the light source flickers at 50 Hz. During each illumination period, we control the ACF2101 to integrate the output current of the photodiode with…
Part Number: TPS922054
Hello, I have used your company's TPS922054 chip to make an LED driver board. The schematic diagram is as follows:
The input voltage range is set at 24 to 28V. I have tried the switching frequency at 2MHz and 680KHz (the calculation…
Other Parts Discussed in Thread: TPS43060 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/tools/simulation-hardware-system-design-tools-group/sim-hw-system-design/f/simulation-hardware-system-design-tools-forum/1618766…
Part Number: OPA891 I have a 0~20mV differential signal ,input common-mode voltage is 12V，signal bandwidth is 10MHz。target Gain is 25V/V，output common-mode voltage is 0V。
I select three OPA891 form an instrument amp as the schematic below。
In the first…
Part Number: LDC1101
Hi,
I want to detect the vibration characteristics of a 10mm-thick aluminum alloy crossbar with a measurement range of 0.5–3mm, using the LHR (High-Resolution Inductance) mode. The sampling rate is set to 10 kSPS.
Now I need…
Part Number: TPS25750EVM Other Parts Discussed in Thread: BQ25731 , Hi Ti Team
If I use Type-C input voltage (PD Max 100W), will it use BATT (TP3) as the output?
Can I pin out a wire from the TP3 pin and charge a device, such as a tablet or laptop?
If it…
