搜索提示
找到 3,787 个结果 查看 问题 帖子 排序依据
    Answered

  • [参考译文] LAUNCHXL-F280025C：在&quot；Motor Control SDK&quot；和&quot；Servo Drive with CAN&quot；之间有不同的硬件配置？

    TI 认为已经解决
    Other Parts Discussed in Thread: LAUNCHXL-F280025C 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/microcontrollers/c2000-microcontrollers-group/c2000/f/c2000-microcontrollers-forum/1492495/launchxl-f280025c-different…
    • Answered

  • [参考译文] CSD95379Q3M：SYNC-BUCK-FET-LOSS-CALC 不能正常工作

    已解决
    Other Parts Discussed in Thread: CSD95379Q3M 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1059674/csd95379q3m-sync-buck-fet-loss-calc-doesn-t-wo…
    • Answered

  • [参考译文] SYNC-BUCK-FET-LOSS-CALC：如何添加替代 MOSFET

    已解决
    Other Parts Discussed in Thread: CSD19502Q5B 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1060176/sync-buck-fet-loss-calc-how-to-add-alternative…

  • RE: DRV8836: There is a problem driving 3.7V hollow cup motor with DRV8836DSSR (12 pin) and we need help urgently

    Hi, DSP硕 说： 1.It should be that there is a problem with the use of DRV8836 chip. The data manual of DRV8836 is not detailed. For example, what signals AIN1 and AIN2 should input are not specified in detail. For full scale stepping, the inputs should be…

  • DRV8836: DRV8836: There is a problem driving 3.7V hollow cup motor with DRV8836DSSR (12 pin) and we need help urgently

    Part Number: DRV8836 Other Parts Discussed in Thread: TMS320F28035 My intention is to use the DRV8836DSSR chip to drive the hollow cup motor, but now there are some problems that I can't solve. The main control chip I use is TMS320F28035 (56 pin)…
    • Answered

  • DRV8306: The ABC three-phase output waveform of the drive circuit designed by DRV8306 is wrong, the motor speed is slow, and the duty cycle cannot be raised to more than 50%

    已解决
    Part Number: DRV8306 The following two signals are the control signal PWM and the A-phase voltage waveform. As shown in the figure, the yellow signal refers to the A-phase voltage waveform, which is A trapezoidal wave. The other green signal represents…
    • Answered

  • TPS51604: 能否配合CSD87333组成三相全桥用于电机驱动Does it fit a three-phase full bridge for motor drive with CSD87333

    已解决
    Part Number: TPS51604 Other Parts Discussed in Thread: CSD87333Q3D , UCC27211 我想使用TPS51604配合 CSD87333Q3D组成三相全桥用于电机驱动。具体情况是： 1 电源电压12~24V； 2 使用7805产生TPS51604栅极驱动需要的5V电压； 3 用MCU的PWM驱动，同时MCU的GPIO端口用两个22k电阻分压后连接nSKIP，GPIO置低时使能驱动，GPIO拉高时nSKIP经电阻分压得到1.6V左右的Tri…
    • Answered

  • [参考译文] LM5069QUICK-CALC：包含 FET 建议的 LM5069设计计算器

    已解决
    Other Parts Discussed in Thread: LM5069 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1338178/lm5069quick-calc-lm5069-design-calculator-with-fet-…

  • MCF8316A: Is MCF8316A capable of driving 120W BLDC? 24v 5A motor.

    TI 认为已经解决
    Part Number: MCF8316A Other Parts Discussed in Thread: DRV8316 Is MCF8316A capable of driving 120W BLDC? we are using a motor from maxon. The power supply is 24V, the current could be up to 5A, That will be 120W power consumption on the MOTOR. The mosfet…

  • LAUNCHXL-F28069M: GaN HEMT drive issues,Permanent magnet synchronous motor control problem

    TI 认为已经解决
    Part Number: LAUNCHXL-F28069M Other Parts Discussed in Thread: BOOSTXL-3PHGANINV , TMS320F28069M 工程师，您好！ 我正在用TMS320F28069M LaunchPad和BOOSTXL-3PhGaNInv做电机控制的实验，但是我的电机正常在转，但是输出电流过流了，电压也特别小，不知道是怎么回事，请您指导一下，谢谢！

未找到您搜索的内容？发布一个新问题吧。