Part Number: ADC3662EVM Other Parts Discussed in Thread: ADC3662
When I used the ADC3662, Configuration mode: 2wire, 16bit, internal reference voltage 1.2*1.33=1.6V, by pass My register configuration is as follows, and I had no problem testing my SPI configuration…
Other Parts Discussed in Thread: C2000WARE 请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/microcontrollers/c2000-microcontrollers-group/c2000/f/c2000-microcontrollers-forum/1262765/tms320f280039c-epwm-interrupt 器件型号…
Hi,
Thanks for the feedback! Input levels in dBm are relative. It would be helpful to have the full signal range to the ADC input in volts. For now, I will assume it is peak-to-peak 0.5V to 12V = 12V-0.5V = 11.5Vpp, as you mentioned in your first post.…
Part Number: PCM4104
PCM4104, configured as fs=96kHz, TDM4, left-aligned, encountered a problem when debugging, the noise is normal, THD+N is very poor (the test point is the analog output pin of the chip):
1. When only CH1 and CH2 data are provided,…
Other Parts Discussed in Thread: TMS320F280039C , ADS7038 请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/microcontrollers/c2000-microcontrollers-group/c2000/f/c2000-microcontrollers-forum/1337412/tms320f280039c-unable…
Other Parts Discussed in Thread: MSPM0G3507 , SYSCONFIG 请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/microcontrollers/arm-based-microcontrollers-group/arm-based-microcontrollers/f/arm-based-microcontrollers-forum…
请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。 您好 Luke、我只是更改了 GPBDIR 寄存器、我怀疑从多路复用器到 GPBDIR 的额外线路会覆盖我的设置? 看起来我无法将 SysConfig 附加到该消息、但我会尝试将其作为代码发布-其中包含我尝试进行的用于正常运行的完整配置。
/**
* These arguments were used when this file was generated. They will…
Other Parts Discussed in Thread: SYSCONFIG , MSPM0G3507 请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/microcontrollers/arm-based-microcontrollers-group/arm-based-microcontrollers/f/arm-based-microcontrollers-forum…