Part Number: TLV320AIC3104-Q1
TLV320AIC3104IRHBR Hello, the correspondence between the external analog amplitude and the converted one is actually artificially defined, which is adjusted by the front-end partial voltage resistor and the internal front…
Other Parts Discussed in Thread: SYSCONFIG 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/microcontrollers/arm-based-microcontrollers-group/arm-based-microcontrollers/f/arm-based-microcontrollers-forum/1270972/mspm0l1306…
Other Parts Discussed in Thread: SYSCONFIG , MSPM0-SDK , MSPM0G3507 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/microcontrollers/arm-based-microcontrollers-group/arm-based-microcontrollers/f/arm-based-microcontrollers…
Hello,
QSGMII works 5Gbps data rate, 1000BASE-SX is 1000Mbps, while DS100MB203 could support 10.3125 Gbps, so it could support both QSGMII and 1000BASE-SX.
About the configuration, I think according to the data rate support, MODE could pull low ( because…
Other Parts Discussed in Thread: MSPM0G1106 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/microcontrollers/msp-low-power-microcontrollers-group/msp430/f/msp-low-power-microcontroller-forum/1527285/mspm0-diagnostic…
Part Number: ADS54J66
Hi, I am using ADS54j66 ADC on my board, and I have met some questions.
1. I want to use DDC mode 8, my sysref clk is 25MHz and sampling clk (clk input at CLKINP/M) is 250MSPS, is the Serdes line rate is just 5Gbps (10Gbps at 500MSPS…
请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 您好！
下面是配置 AIN7的示例。
//
// The ADC0 peripheral must be enabled for use.
//
SysCtlPeripheralEnable(SYSCTL_PERIPH_ADC0);
//
// For this example ADC0 is used with AIN7 on…
Part Number: TLV320ADC5140
I'm currently using an STM32F407ZGT6 to control a TLV320ADC5140 using SPI communication to receive audio using I2S, but I'm unable to capture the audio data. Acquisition method: analog dual channel input。
STM32 as host…
