The diode is not necessary.
The AC coupling cap is required on both legs as well as the MICBIAS resistor to provide bias to the ADC input pins. Check the diagrams in the data sheet for references on this.
There is a link in the datasheet to a tool…
Other Parts Discussed in Thread: UNIFLASH 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/tools/simulation-hardware-system-design-tools-group/sim-hw-system-design/f/simulation-hardware-system-design-tools-forum/1638946…
The 98x Script Gen Tool has an option to configure FPD-Link forward channel SSCG. Are you needing to generate a script for a specific configuration? I can generate a script for you if you know the FPD-Link rate (3.375Gbps, 6.75Gbps, etc.).
TI有过回复，您按照下方指导进行操作。
(+) MSP430F149 Rev AE: unable to program - MSP low-power microcontroller forum - MSP low-power microcontrollers - TI E2E support forums
Part Number: MSPM0G3507 MSP Zero Code Studio cannot compile and run. I was connected to mspm0g3507 and the CCS showed that my development board was successfully connected to the computer.Please tell me how to solve it, thank you very much.
Part Number: DS90UB988-Q1
When conducting communication tests, there is a chance that 988 will not forward IIC messages. When we separately connect the IIC tool to 988 and the MCU, the tool can send messages to the MCU. Therefore, it is determined that…
参考下方链接的处理方法。
(+) EVM430-FR6043: Time between measurements is greater than UPS0 to UPS1 Gap - MSP low-power microcontroller forum - MSP low-power microcontrollers - TI E2E support forums
