Part Number: TIDA-01606 T-type三电平-TIDA-01606。使用DSP28379控制卡。控制卡无法正常发出驱动板上的PWM使能信号。也就是程序中的PWM—EN信号无法正常输出高电平。驱动板上的隔离芯片SN74LVC126APWR无法正常开启。驱动芯片无法接收pwm波信号，前级控制卡输出的PWM正常。
Part Number: TIDA-01606
hello
The switching and conduction losses for Q1 and Q3 in inverter mode are given in this reference design, can you provide us with the switching and conduction losses in rectification mode and how they are calculated？
THA…
Part Number: TIDA-01606
hello:
Regarding the circuit in the diagram, my understanding is that in PFC mode, pre-charging is performed through RF1-RF4 first, and then the DSP provides a control signal to close the relay. However, in the experiment, I did…
Other Parts Discussed in Thread: TIDA-01606 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/tools/simulation-hardware-system-design-tools-group/sim-hw-system-design/f/simulation-hardware-system-design-tools-forum…
Part Number: TIDA-01606
hi Regarding the TIDA-01606 reference design, I would like to know if the E6 version uses SPWM or SVPWM? I didn't see any introduction to it in tinv_F28379D engineering; In my understanding, it seems that SVPWM is used, but…
Other Parts Discussed in Thread: TIDA-010938 , TIDA-01606 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/tools/simulation-hardware-system-design-tools-group/sim-hw-system-design/f/simulation-hardware-system-design…
Other Parts Discussed in Thread: TIDA-01606 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/tools/simulation-hardware-system-design-tools-group/sim-hw-system-design/f/simulation-hardware-system-design-tools-forum…
Other Parts Discussed in Thread: TIDA-00364 , TIDA-01543 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/tools/simulation-hardware-system-design-tools-group/sim-hw-system-design/f/simulation-hardware-system-design…
