Hello Martain Bao , It should be fine for them to share the same sense resistor. I would recommend not using vias on this path as it'll add resistance to the path and possibly affect measurements. Keep the signals on the same layer and same paths. These…
Clarifications Needed
Before diving in, a few details from your posts would help refine this further:
When you say "driver loss," are the gate signals completely absent during portions of the cycle, or are they intermittent/degraded in amplitude…
Part Number: TIDA-01606
hello
The switching and conduction losses for Q1 and Q3 in inverter mode are given in this reference design, can you provide us with the switching and conduction losses in rectification mode and how they are calculated？
THAN…
Other Parts Discussed in Thread: TIDA-01606 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/tools/simulation-hardware-system-design-tools-group/sim-hw-system-design/f/simulation-hardware-system-design-tools-forum…
Part Number: BQ25638 Hi TI team,
I found the dual-input charger design in a TI application note. I noticed that with two chargers, only one SYS pin is active and both charger outputs are connected only at the BAT pin. I have the following questions:
…
Part Number: BQ25638 Hi TI team,
I found the dual-input charger design in a TI application note. I noticed that with two chargers, only one SYS pin is active and both charger outputs are connected only at the BAT pin. I have the following questions:
…
