您好，请参考下面内容
The answer depends on whether the FET configuration is high-side or low-side.
For high-side, see the TIDA-010247 reference design schematic for how we recommend connecting the LD and PACK pins on both devices.
For low-side, see the figure below…
Part Number: CC1354P10 Other Parts Discussed in Thread: BLE-STACK MAP_GapInit_cancelConnect() resolves to trap (E7FE) in SDK 8.31 causing infinite loop during initiating cancel
Environment
SDK Version: SimpleLink CC13xx/CC26xx SDK 8.31.00.11
Device…
Yes, the TXS0102 can be used for I2C/I3C applications if the desired data rate/ switching performance aligns with the customer's setup.
You may also refer to Voltage Translation Application Quick Reference for more device recommendations.
Hi，
This is an Application Note on how to design an isolated flyback regulator using the LM5155, which includes example applications and component selection methods. You can see if you can refer to it， www.ti.com.cn/.../zhcac13a.pdf
Solved. It seems that the hardware 4-wire SPI mode is somewhat unstable — the CS release appears to be controlled by whether the TXFIFO is empty. I switched to 3-wire mode with manual CS control
This issue is now resolved. I might try a solution…
Part Number: LMK04828
Hello,
I have a question about the recommended AC-coupled LVDS input connection for LMK04828.
In the datasheet, the 100 Ω differential resistor is placed before the AC coupling capacitors. But in many other LVDS application notes…
Part Number: LMK1D1208
Dear TI Technical Support Team,
I am currently working on the schematic design for the LMK1D1208 buffer. I have selected a 3.3V single-ended LVCOMS signal as the input, based on the device specifications. However, I have encountered…
Other Parts Discussed in Thread: AWR2243 , AM2732 , TIDA-020047 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/tools/simulation-hardware-system-design-tools-group/sim-hw-system-design/f/simulation-hardware-system-design…
