Part Number: TIDM-02013 Hello! I would like to know why the pin 14 defined in the schematic diagram is different from that in the manual, and what impact it has on practical application? Thank you!
Part Number: TIDM-02013 Hello! I haven't found the corresponding LMG3525R030Q-GaN-Mosfet in the BOM list. So which Mosfet can be used as a substitute in practice?
Part Number: TIDM-02013 Other Parts Discussed in Thread: TMDSCNCD280039C Hi,
I have purchased this control card TMDSCNCD280039C and the complimentary item included a USB cable.
And the circuit board has already been soldered.
When I wanted to start the…
Part Number: TIDM-02013 Hello! The specification sheets of these two current transformers do not mention the primary side current and the number of turns of the coils. I have been unable to contact the engineer who manufactured these current transformers…
Other Parts Discussed in Thread: SFRA , TIDM-02013 , SYSCONFIG 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1519306/tidm-02013-tidm-02013 器件型号： TIDM…
Part Number: TIDM-02013
Dear expert.
When the frequency is below 400 kHz, the voltage Vds across the secondary-side switches exhibits sudden rises and falls. As the frequency decreases, the peak values of these sudden changes become larger. What is this…
Other Parts Discussed in Thread: TMDSCNCD280039C , TIDM-02013 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1501018/tidm-02013-communication-problems…
Other Parts Discussed in Thread: TIDM-02013 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/microcontrollers/c2000-microcontrollers-group/c2000/f/c2000-microcontrollers-forum/1595749/tidm-02013-overcurrent-alarm 器件型号…
hi,
I followed the steps of the first experiment, but failed to generate the PWM waveform.
This experiment is not supposed to be verifying the PFC, so why did you input a direct current voltage of 120?
Could you please tell me exactly how to conduct…
