Part Number: TIDM-02013
When the control card is not inserted into the tdim-02013, the GPIO port can detect the output PWM waveform. When the control card is inserted, the voltage across C164 is measured, but no voltage PWM signal can be detected. What…
Part Number: TIDM-02013 Other Parts Discussed in Thread: PMP22650
The blue waveform represents the secondary - side current, while the others are the two - channel secondary - side driving signals. As shown in the figure, the synchronous rectification…
Part Number: TIDM-02013
Hello, experts. I would like to know the method adopted to achieve the leakage inductance of the transformer T1 in this solution. Is it realized by cutting air gaps in the side columns of the transformer, or by means of the main…
Part Number: TIDM-02013 Other Parts Discussed in Thread: TIDM-02008 , PMP22650
Hello, expert. I'm sorry to disturb you.
Both Experiment 2 and Experiment 1 adopt current loop feedback regulation. However, Experiment 2 states that when the AC current…
Part Number: TIDM-02013
Hello, expert. I'm sorry to bother you.
Regarding the overcurrent protection in Lab 3, when I run the program, it will enter the judgment condition of if((TTPLPFC_PWM_TRIP_STATUS(TTPLPFC_LOW_FREQ_PWM_BASE) & EPWM_TZ_INTERRUPT_DCAEVT1…
Part Number: TIDM-02013
Hello, I am conducting Lab 1 of the PFC stage. When I follow the experimental steps:
1：Apply a fixed duty cycle of 0.5 with an input voltage of 35V. The DCLINK value will quickly rise to around 120V, then drop rapidly to about…
Part Number: TIDM-02013 Other Parts Discussed in Thread: TMS320F280039C , , TMDSCNCD28388D 请问一下，这个TMS320F280039C controlCARD是否对应 TIDM-02013文件中所给原理图的 HSEC连接器，我看样板中所对应的是TMDSCNCD28388D,引脚定义是否要改变。
Other Parts Discussed in Thread: TIDM-02013 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1329496/tidm-02013-evk-tidm-02013-buy-in-ti 器件型号： TIDM-02…
Part Number: TIDM-02013
Dear Expert,
I hope this message finds you well.
Since I can't post a new question on the forum, I'm bringing it up here.
While reading another article, I came across settings for starting and disabling TTPLPFC and CLLLC…
Other Parts Discussed in Thread: TIDM-02013 , TIDM-02002 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/microcontrollers/c2000-microcontrollers-group/c2000/f/c2000-microcontrollers-forum/1524980/tidm-02013-calculations…
