E2E™ 设计支持
E2E™ 设计支持
  • 用户
  • 站点
  • 搜索
  • 用户
  • E2E™ 中文设计支持 >
  • 论坛
    • 放大器
    • API 解答
    • 音频
    • 时钟和计时
    • 数据转换器
    • DLP® 产品
    • 接口
    • 隔离
    • 逻辑
    • 微控制器
    • 电机驱动器
    • 处理器
    • 电源管理
    • 射频与微波
    • 传感器
    • 站点支持
    • 开关与多路复用器
    • 工具
    • 无线连接
    • 参考译文
    • 存档组
    • 存档论坛
  • 技术文章
    • 模拟
    • 汽车
    • DLP® 技术
    • 嵌入式处理
    • 工业
    • 电源管理
  • TI 培训
  • 快速入门
  • English
  • 更多
  • 取消


搜索提示
找到 3,192 个结果 查看 问题 帖子 排序依据
    Answered
  • [参考译文] DCA1000EVM:SO# 425584 — 从 DATA_TRAN_PRG 发出的任何灯都没有在烧焦气味后亮起...

    admin
    admin
    已解决
    Other Parts Discussed in Thread: AWR1843BOOST , DCA1000EVM 请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/sensors-group/sensors/f/sensors-forum/1566147/dca1000evm-so-425584---none-of-the-lights-from-data_tran_prg…
    • 已回答
    • 3 个月前
    • 传感器(参考译文帖)
    • 传感器(参考译文帖)(Read Only)
  • RE: LM3410: Flash lamp design based on LM3410

    shiyu zhang
    shiyu zhang
    No, I just refer to the circuit, my circuit is 3 3535 LED, the current limiting resistor I selected is 1602 package 0.2 ohm resistor, transistor is B3, inductance I use 0420 molded inductance size of 4.7uh, I do not know whether reasonable, capacitance…
    • 1 年多前
    • 电源管理
    • 电源管理论坛
  • [参考译文] TMS320F28P650DK:C2000的降压稳压器控制、开关频率为3MHz

    admin
    admin
    Other Parts Discussed in Thread: TIDM-DC-DC-BUCK , PMP41081 请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/microcontrollers/c2000-microcontrollers-group/c2000/f/c2000-microcontrollers-forum/1338463/tms320f28p650dk…
    • 1 年多前
    • C2000™︎ 微控制器(参考译文帖)
    • C2000™︎ 微控制器(参考译文帖)(Read Only)
  • AWR2243BOOST: LED

    orange hou
    orange hou
    TI 认为已经解决
    Part Number: AWR2243BOOST Other Parts Discussed in Thread: AWR2243 Dear engineer, when I was installing the board, I accidentally knocked off the LED light and resistor above the mark "warmrst". Will the radar function be damaged after it was knocked off…
    • 1 年多前
    • 传感器
    • 传感器论坛
  • Answered
  • [参考译文] ISO1228:LED 指示灯异常

    admin
    admin
    已解决
    Other Parts Discussed in Thread: ISO1228 请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/isolation-group/isolation/f/isolation-forum/1413487/iso1228-abnormal-led-light 器件型号: ISO1228 工具与软件: 嗨、团队: 我的客户使用 ISO1228、他们发现…
    • 已回答
    • 1 年多前
    • 隔离(参考译文帖)
    • 隔离(参考译文帖)(Read Only)
  • RE: TIDA-01606 整流实验问题

    L C
    L C
    Hello, the problem seems to have found, today I found the AB phase drive Q4 Q3 at the DC-DC conversion lamp did not light, I tested and found two mosfet gate source pole short circuit, mosfet bad, I replaced and then did a little experiment, in my reference…
    • 2 年多前
    • C2000 微控制器
    • C2000™︎ 微控制器论坛
  • Answered
  • RE: [参考译文] TLC6C5716-Q1:ERR 引脚在不存在错误的情况下置位。

    admin
    admin
    已解决
    请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。 您好、Gracie: SID 寄存器中没有设置 ERR 位、只在保留段中设置位。 当我启用 LED_ERR 屏蔽时、这些位也不再设置。 我曾尝试在 FC-BC-DC 标志中屏蔽 ERR 位、但是灯停止亮起。 但是、我希望将此引脚用作 uC 上的中断源、以便异步检测错误。 为此、ERR 引脚是否能够正常工作? 做出这种更改后、R0 LED 仍然比其余 LED 更暗。 所有 LED…
    • 1 年多前
    • 电源管理(参考译文帖)
    • 电源管理(参考译文帖)(Read Only)
  • Answered
  • [参考译文] TPS92662A-Q1:IMDS 97542 / Marelli Motherson Automotive Lighting Ind Pvt Ltd

    admin
    admin
    已解决
    请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1524201/tps92662a-q1-imds-97542-marelli-motherson-automotive-lighting-ind-pvt-ltd 器件型号: TPS92662A-Q1 …
    • 已回答
    • 6 个月前
    • 电源管理(参考译文帖)
    • 电源管理(参考译文帖)(Read Only)
  • [参考译文] DCA1000EVM:[DCA1000 ]仅电源 LED 在上电后亮起、FPGA 配置失败–我的电路板是否损坏?

    admin
    admin
    Other Parts Discussed in Thread: DCA1000EVM , IWR6843ISK 请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/sensors-group/sensors/f/sensors-forum/1523440/dca1000evm-dca1000-only-power-led-lights-up-after-power-on-fpga…
    • 6 个月前
    • 传感器(参考译文帖)
    • 传感器(参考译文帖)(Read Only)
  • BQ34Z100-R2: BQ34Z100-R2 1PIN,3PIN How to set the register output high and low?

    ?? ?
    ?? ?
    TI 认为已经解决
    Part Number: BQ34Z100-R2 Dear Evan, May I ask how to set the 1pin and 3pin of BQ34Z100-R2 to high and low level for lighting LED? How to set the register output high and low?
    • 1 年多前
    • 电源管理
    • 电源管理论坛
<>

未找到您搜索的内容?发布一个新问题吧。

  • 发布新问题