Other Parts Discussed in Thread: TIDM-RFID-TRANSCEIVER 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/wireless-connectivity/sub-1-ghz-group/sub-1-ghz/f/sub-1-ghz-forum/1551515/tidm-rfid-transceiver-evaluation-to…
Part Number: TIDM-02013 Other Parts Discussed in Thread: TMDSCNCD280039C , TMDSHSECDOCK , , PMP22650
Hi,
My team and I are replicating this circuit board.
When I was not connected to an auxiliary power source （12v 2A）, JTAG is normal.
But when I connected…
Part Number: TIDM-02013 Other Parts Discussed in Thread: TMDSCNCD280039C Hi,
I have purchased this control card TMDSCNCD280039C and the complimentary item included a USB cable.
And the circuit board has already been soldered.
When I wanted to start the…
Other Parts Discussed in Thread: J784S4XEVM 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/processors-group/processors/f/processors-forum/1573324/j784s4xevm-network-connectivity-loss-under-high-traffic 器件型号： J784S…
Hi, The ports circled in the picture should be the network ports on the board. I am using the UDP example located in the folder [C:\ti\mcu_plus_sdk_am273x_08_05_00_24\examples\networking\lwip\enet_cpsw_udpserver] to develop for the board. After using an…
Part Number: TIDM-02010 In the design scheme TIDM02010A of TI's 1.5kw compressor, I noticed that the power ground PGND was not completely isolated from the signal ground GND. However, the power supply design scheme already used a flyback power supply,…
