Part Number: LAUNCHXL-F280049C Other Parts Discussed in Thread: C2000WARE
Hello TI team, I am currently working on motor control applications with the F28004x series (e.g., F280049C). I noticed that the Motor Control SDK Universal Project and Lab provides…
Part Number: TL074H Other Parts Discussed in Thread: TINA-TI
您们好，TI专家们！ 我采用pspice for ti设计复合放大器进行AC仿真发现了收敛性问题。瞬态仿真时，可以采用复选SKIPBP选型来收敛仿真，但AC仿真因为无法跳过直流工作点仿真，一直收敛不了，请问有解决办法吗？以下是仿真原理图和仿真设置：
Part Number: TIDM-02013
Hello, I am conducting Lab 1 of the PFC stage. When I follow the experimental steps:
1：Apply a fixed duty cycle of 0.5 with an input voltage of 35V. The DCLINK value will quickly rise to around 120V, then drop rapidly to about…
Hi,
When using Ac coupling, the common mode of the HDMI signal will be 0V. This means that the data will be centered around 0V. This will require the use of external AC coupling capacitor and configuring the TMDS1204 correctly. Using AC coupling will…
Part Number: DP83867IS Hi, we are using TI Enet PHY chip DP83867ISRGZ (SGMII to MDI) for PHY2 & PHY3. For MDI interface of PHY3, we use AC coupled capactiors instead of transformers, is there any difference need to note to set PHY registers for below…
Part Number: LP-MSPM0L1306
Dear Sir,
I want to know if it is possible for the following case.
. set I2C be controller mode with 400k and do communication with a target device.
. after finishing, do
DL_I2C_disablePower(I2C_INST)
DL_I2C_disableController…
Part Number: TIDM-DC-DC-BUCK Digitally Controlled Non-Isolated DC/DC Buck Converter Reference Design
Unable to open schematic and PCB in design hardware support
TIDM-DC-DC-BUCK reference design | TI.com
Looking for hardware design resources, thank you
Part Number: TIDM-BIOSIGNMONITOR I would buy 2~3 pieces of "TIDM-BIOSIGNMONITOR Multi-Parameter Bio-Signal Monitor Reference Design For Personal Monitoring design" reference board, may I know the sales contact and unit price?
Part Number: TMDXRM57LHDK CCS用XDS100v2 USB Debug Probe烧录程序报(Error -180 @ 0x0)错误： The controller has detected a target power loss. The user must turn-on or connect the power supply for the target.
请问是否是开发板上硬件有问题？
