您好
I'm not clear on which HW version you have. I assume it's rev E6 because of the OPA part number you mentioned.
Was this HW from TI or did the customer build their own?
You mentioned that the customer measured the op amp output with an oscilloscope…
Part Number: AM3358
I have a custom board based on am3358, and I got a LCD screen connected to it.
I tried linux kernel with version 4.4.93, and the LCD screen works fine, but while I am using kernel v5.9, the LCD screen doesn't work.
My dts configure…
Other Parts Discussed in Thread: TIDM-02018 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/motor-drivers-group/motor-drivers/f/motor-drivers-forum/1500077/lp-am263p-motor-control-sdk-configuration 器件型号： LP-AM263P …
Part Number: LM3478Q-Q1 Other Parts Discussed in Thread: LM3478
when power supply increased from 0V to 5V and MOSFET controlled as open，we found the frequency in DR pin is change，but finally DR pin will driver to high for a long time.
Question from my…
Part Number: UC2845 Dear TI Support Team,
I am currently designing a Flyback converter using the UC2845 PWM controller. I am encountering some abnormal behaviors during the startup phase and would appreciate your professional insights.
System Specifications…
Part Number: TIDA-01606
hello:
Regarding the circuit in the diagram, my understanding is that in PFC mode, pre-charging is performed through RF1-RF4 first, and then the DSP provides a control signal to close the relay. However, in the experiment, I did…
Thank you for your patience. Here are the answers to your questions.
All Table and Section references (unless otherwise noted) come from this document: TDA4VPE-Q1, TDA4APE-Q1 Jacinto Automotive Processors datasheet (Rev. A)
1. Yes, the TDA4VPE has 6 Enhanced…
