请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 您好、Berlam：
对延迟回复深表歉意。
我看了看你的日志,看到一些有趣的事情。 因此、您要加载日志中报告的大小为392KB 的应用程序。 然后、您定制电路板报告的 CPU 负载时间(587019us)似乎比 TI EVM 报告的 CPU 负载时间(2647us)更合理。
在下面附加来自我的 TI EVM 的引导日志
DMSC Firmware Version 8.6…
Hi Eddie, Below are my comments: 1. It looks like the devices are set to I2C mode. Why is the customer having pulldowns on SDA/SCL?
2. Based on the DDC connections, it looks like DDC buffer is disabled. However, the customer has HV_DDC connected. Was this…
Hello Eric,
I want to ensure that I know that I know the input signal properly.
Eric Sun 说： amplitude is peak-to-peak 0.5V to 12V, and the modulation ratio is 6:1 to 2:1.
The minimum 0.5Vpp for high bit and (0.5V/6) = 0.83Vpp for low bit
The maximum…
Part Number: CC2340R5 Hello TI ,
I am excited to see the DMM (Dynamic Multi-protocol Manager) solution implemented in the latest SimpleLink LowPower F3 SDK (v9.20.00.81). I am currently working with the CC2340 series for an IoT project.
Currently, I do…
Other Parts Discussed in Thread: TIDM-02003 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/microcontrollers/msp-low-power-microcontrollers-group/msp430/f/msp-low-power-microcontroller-forum/1475069/evm430-fr6043…
Part Number: DRV8316 The power-up sequence is normal, as shown in the figure below for the DRV8316's VM and FAULT pins. SLEEP has been kept low. The blue trace is the VM pin, and the yellow trace is the FAULT pin.
However, when the MCU reads the DRV8316…
Part Number: DRV8316 The power-up sequence is normal, as shown in the figure below for the DRV8316's VM and FAULT pins. SLEEP has been kept low. The blue trace is the VM pin, and the yellow trace is the FAULT pin.
However, when the MCU reads the DRV8316…
Thanks for your reply!
Hello,According to the suggestion:" datasheet 19 page “The VSET voltage is applied using a DAC through a 20kΩ series resistor.",
Setting conditions:
single-ended input;DC bias 2V/AVDD 3.3V OR 3V/AVDD 5V
(PD…
