Please refer to below files
4401.Using EDID in FPD-Link Devices (1).pdf
TRANSLATE with x
English
Arabic
Hebrew
Polish
Bulgarian
Hindi
Portuguese
Catalan
Hmong Daw
Romanian
Chinese Simplified
Hungarian
Russian
Chinese Traditional
Ind…
Part Number: TIDM-02013
Hi,as shown in the figure,lab 1 to 4 are all aimed at verifying the PFC mode.
However, why did lab 1 and 2 use DC as the input, rather than AC voltage?
Part Number: TMS320F280039C Other Parts Discussed in Thread: TIDM-02013 , Hi !
I am referencing the TIDM-02013 design for a Totem-Pole PFC implementation. Is it possible to perform pure software simulation without hardware? If yes or no, what steps should…
Part Number: TIDM-02013
When the control card is not inserted into the tdim-02013, the GPIO port can detect the output PWM waveform. When the control card is inserted, the voltage across C164 is measured, but no voltage PWM signal can be detected. What…
Part Number: TDC1000 Other Parts Discussed in Thread: MSP430FR6043 , , TIDM-02003
Dear TI Support Team,
I am currently developing an ultrasonic gas meter measurement circuit based on MSP430FR6043, and the overall architecture is inspired by the SNAA284A…
你好,参考下工程师的回复:
With AC input it works as a PFC input stage. It boosts the input volt to generate a higher DC bus volt and shapes the input current. This is average current mode control (ACMC) AC/DC boost.
But for DC input, it will be the same except that…