Hi,
The 20kohm is not necessary. Not having the 20kohm resistor will only cause a offset current error of few 10s of uA in the output current.
The VSET input pin a high impedance input, so the current going into the pin will be <100pA. So if there is a…
Part Number: UCD90120A
I'm using TI's USB Interface Adapter and encountered an issue when modifying VADJ to 1.8V.
After powering on the ZC706, following the tutorial, the system prompted "Please Cycle Board POWER [off/on] and press OK when done…
Part Number: TAS2781 hi
I have a question about TAS2781 input power.I used an extral 20V/1.75A adapter power for TAS2781EVM,setup under this configurationconfiguration.
I tested PA input power by oscilloscope,I measured PA input Voltage and PA input current…