Part Number: TPS2663 Other Parts Discussed in Thread: BQ25690
Hello, we aim to implement a hardware circuit system architecture similar to the block diagram below.
Using a 24 V bus, with an input power supply of 24 V/1.5 A. This system incorporates a lithium…
For re-driver mode, please see below the propagation delay.
For re-timer mode, the propagation delay depends on the input signal quality as the RX CDR needs to adapt, so it is a variable and not a fix number.
Based on this message, you are trying to flash firmware onto the UCD3138 via JTAG and Code Composer Studio (CCS). This requires the XDS110 debugger , as shown in the error message's title.
The USB-TO-GPIO2 is a PMBus/I2C adapter, not a JTAG adapter. The…
Part Number: AM625 hello everyone:
I am using a module based on I2C0 bus on AM6254, and I need to use SMBus Quick mode to scan the module. However, AM6254 does not support this mode.
The specific printing information is as follows:
root@evse:~# ls /dev…
Part Number: BQ25856EVM Other Parts Discussed in Thread: BQSTUDIO
In my test, the EN_REV bit will not enabled when the adapter is connected to the system. However, if the BQ25856EVM is already at reverse-mode without any adapter, the reverse mode will…
