Part Number: LM5146-Q1 1: I saw the output current capability technical parameters of LM5146-Q1 as 20A/30A on TI's official website. What parameter limit of the chip does this output current capability limit depend on? Or is it considered the external…
Part Number: LM5121 LM5121这款芯片的inrush current limit功能简直一坨屎，设计这款芯片的人肯定没有完整地试过全电压范围，他根本很不懂inrush MOSFET要承受所有输出电容的充电能量。当输出负载或者输出电容足够大时，inrush MOSFET必定损坏，人类现有材料学是无法满足所有设计的。难道不能设计一个inrush的选择开关吗？本论坛里那么多因inrush功能损坏的案例，原厂设计者无动于衷？一点解释都没有吗？别跟我提其他型号，当你在大公司打工久了就知道…
Part Number: TPS65994AD Hi TI
TPS65994 目前在做Thunderbolt功能时，客户需要限流1.5A，实际我们在Application Tool里面 Source PDO1里面的Maximum Current设置为1.5A,实测抽载到2.4A才保护,想确认下限制输出电流是否是在这边设置,另外如果设置正确,这样的行为是否正常？
Part Number: TPS1H100-Q1 TPS1H100BQPWPRQ1 is currently using an rush current of around 5A
According to the specification calculation, the resistance value of Rcl is set at 540 ohms；
The current limit is exactly 5A, and the voltage drops by 1V, but at low…
Part Number: UCD3138ALLCEVM150 When I use a DPWM2 module and a comparator D to trigger a period-by-period current fault:
The setting of DPWM2 is:
In the open loop state, set the mode to normal mode, period value, and event 1, 2, 3, and 4 values to 10000…
Part Number: TPS65177
I need to know what is the “ Boost Current Limit Negative Offset Current Register ”means in page-43 on TPS65177 datasheet。
If I setting Address 03h to 05H，that means Ioffset = 2.0A，
What is the meaning of Ioffset = 2.0A…
Part Number: LM3489 hi Dears
Base on design with Webench design reference , Vin ·4.5V~35V, VOUT 3.8V 0.1A, I chose 220uH 0.45A,0.8R inductor, but during start up , current though L could be reach 1.5A with 100us, 1.5A is more over 0.45A, so…
Part Number: UC3825 3825手册上写Ilim引脚门槛电压是1V
现在做一个同步boost，模拟控制用运放比较器做的，但是启动过程中电感电流上存在一个启动冲击电流，现在想换用3825来做控制，看了下3825带pulse by pulse current limit，那这个功能能否在启动中限制启动冲击电流，是否为检测到电流超过门槛，就关闭两个驱动还是关闭其中的一个？麻烦详细说说，谢谢
