Thank you for your response. I'd like to ask:
What different behaviors would the Charger IC exhibit when the CELL_BATPRESZ pin is pulled low versus not pulled low in the absence of a battery?
What is the correct connection method for the CELL_BATPRESZ…
Other Parts Discussed in Thread: LM70660 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1649880/lm70660-rshunt-current-limit 器件型号： LM70660 尊敬的团队：
能否请您确认…
The LED current can be set, and controlled dynamically, by using the IADJ pin of the TPS92512. Below equation shows how to calculate the value of the current setting resistor (RISENSE) from the ISENSE pin to ground for the desired LED current.
The IADJ…
Part Number: LM5190 Other Parts Discussed in Thread: UCC27884 , Hello guys,
Recently, I have been designing a buck converter with an input range of 75V to 130V, a 12V output, and a total power of 240W. I intend to use an analog solution, but I found that…
Part Number: LM5190 Other Parts Discussed in Thread: UCC27884 , Hello guys,
Recently, I have been designing a buck converter with an input range of 75V to 130V, a 12V output, and a total power of 240W. I intend to use an analog solution, but I found that…
?? ? 说： when I use DRV110 drive the Electromagnetic brake, I found if my pwer supply is 48V, then the VIN is going to be 15V, because of the function of 15V zener diode inside, but the OUT pin PWM frequency became unstable, and the Electromagnetic brake…
