您好，请参考下面内容：
you can set the device to recover solely with a charge current. You will have to enable SCDL (Settings:Protection:Enabled Protections C:[SCDL]) and set SCDL limit (Protections:SCDL:Latch Limit) to 1, so that it triggers after a single SCD…
Other Parts Discussed in Thread: TPS2041 , TPS22950 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1539764/suggest-alternative-to-bd2221g-tr-current…
Other Parts Discussed in Thread: UCC23513 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1467294/ucc23513-output-current-and-gate-resistance-calc 器件型号…
I posed this question to an AI, and it provided the following response. Is this statement correct?
Analysis of the Reason Why BQ4050 Fuel Gauge's Full Charge Capacity (FCC) Locks at (Design Capacity - 256 mAh)
Core Issue Analysis
The phenomenon where…
1.For point 1, and given the debug setup, it seems that the pin is damaged. A 50k or 100k PD resistor should be a very small resistive load to drive HIGH. What I mean, is that the VOH should be near VCC under good case, since the pFET pulls the pin HIGH…
Part Number: OPA855 Dear TI Technical Support Team,
I hope this message finds you well.
I am currently working on designing optical front-end systems. Recently, I have been exploring the use of current-feedback operational amplifiers (CFOAs) in the…
HI
见datasheet描述：
Since the ramp amplitude is proportional to VIN - VOUT, if VOUT is shorted, there is an immediate reduction in duty cycle. To further protect the external switches during prolonged current limit conditions, an internal counter counts…
Hi
T3-1
Assembled Board with an external supply current limited, turn on the DC input power; Check DC in to 3.3v
measure DCtoDC converter 3.3v out, value, ripple/noise. Record DC into 3.3v ISK board
T3-2
Assembled Board, DC In applied, release PMIC…
Hi，
1. For DRV8873, in PWM mode, mcu controller drv8873 by nSLEEP, DISABLE, IN1 and IN2 pins, operat, how to set the input can operate drv8873 from forward to slow decay(or fast decay)? I'm not sure my operate is right, because when motor from full speed…
