您好
根据官方datasheet显示有两种模式您可以按照您的需求进行选择：
1、这种模式是您说的GND接电容接地的模式，是达到限电流保护模式，优势就是可以在突发情况下保护您的电路，缺点是保护后没有自动恢复。
Latch-off mode is active when the DELAY pin connects to GND through a capacitor. When a current limit is reached, the output current holds at the setting…
Hi
感谢您对TI产品的关注！关于 Icl2，可以参考数据表8.3.1 Current Limit中的解释： www.ti.com.cn/.../tps23525.pdf
也可以参考这个资料的3.3 Dual Current Limit中的内容： Protecting Radio, Baseband and Active Antenna Systems with TPS2352x Hot Swaps
Hi,
I think it is power limited (maby peak current limit or short circuit protection)
Please share more waveforms: transformer primary current, SW, Vin, Vout, gate signal.
Plesase also share the schematic.
Best Regards,
Links
TRANSLATE with x
Engl…
Part Number: TPS23861 dears,
TPS23861 may limit the output current by step according to the classification settings as below:
the customer is wondering if there is any method to adjust the current limit accurately and flexibly according to the customer…
If the current is being limited by the current set ITRIP threshold, then the ITRIP threshold can be changed to a new value or to be disabled while the motor is running, this is fine. If the CONFIG registers are locked with REG_LOCK then these bits will…
Thank you for your response. I'd like to ask:
What different behaviors would the Charger IC exhibit when the CELL_BATPRESZ pin is pulled low versus not pulled low in the absence of a battery?
What is the correct connection method for the CELL_BATPRESZ…
Hi Links,
1.When the battery is not present, the input current of BQ25792 seems to be limited to below 1A. Is there any way to lift this restriction?
Is the device reporting a BATOVP here? What is your ILIM_HIZ resistor value? What is your IINDPM…
