Other Parts Discussed in Thread: TPS25940-Q1 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1581636/tps250x-current-limit-calc-tps25940-q1-tina-simulation…
Part Number: TL494
I used TL494 in my circuit to limit the charging current of the battery. The original circuit worked normally, but when I removed capacitor C157, the current value was incorrect. Why is this？TKS！
Part Number: UC1524A
hi guys
currently I'm using UC1524AJ to built a converter, but I can't find the current limit threshold voltage for current sense pin. Could you guys tell me the threshold, the version of my datasheet is SLUS181B revised APR 2007…
Other Parts Discussed in Thread: TPS25940-Q1 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1582078/tps250x-current-limit-calc-tps25940aqrvcrq1-simulaion…
Part Number: LM5146-Q1 1: I saw the output current capability technical parameters of LM5146-Q1 as 20A/30A on TI's official website. What parameter limit of the chip does this output current capability limit depend on? Or is it considered the external…
Part Number: LM5121 LM5121这款芯片的inrush current limit功能简直一坨屎，设计这款芯片的人肯定没有完整地试过全电压范围，他根本很不懂inrush MOSFET要承受所有输出电容的充电能量。当输出负载或者输出电容足够大时，inrush MOSFET必定损坏，人类现有材料学是无法满足所有设计的。难道不能设计一个inrush的选择开关吗？本论坛里那么多因inrush功能损坏的案例，原厂设计者无动于衷？一点解释都没有吗？别跟我提其他型号，当你在大公司打工久了就知道…
Part Number: TPS65994AD Hi TI
TPS65994 目前在做Thunderbolt功能时，客户需要限流1.5A，实际我们在Application Tool里面 Source PDO1里面的Maximum Current设置为1.5A,实测抽载到2.4A才保护,想确认下限制输出电流是否是在这边设置,另外如果设置正确,这样的行为是否正常？
Part Number: TPS1H100-Q1 TPS1H100BQPWPRQ1 is currently using an rush current of around 5A
According to the specification calculation, the resistance value of Rcl is set at 540 ohms；
The current limit is exactly 5A, and the voltage drops by 1V, but at low…
Part Number: UCD3138ALLCEVM150 When I use a DPWM2 module and a comparator D to trigger a period-by-period current fault:
The setting of DPWM2 is:
In the open loop state, set the mode to normal mode, period value, and event 1, 2, 3, and 4 values to 10000…
