Other Parts Discussed in Thread: TPS61376 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1562396/tps61376-tps61376-alternatives-with-average-input…
meme wang 说： Could you clarify which pin is used to set this certain current value? The ICHG pin is used to set pre-charge, ICHG, and the termination current. For a capacitor, you'll want to set EN_TERM=0 and EN_PRECHG=0 to disable termination and precharge…
This is a complex topic with many considerations. Some general advice I can give:
Layout your analog and digital connections for separate ground planes, but you can connect the digital and analog GND planes to get the best of both worlds (layout designed…
Other Parts Discussed in Thread: TPS55285 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1568336/tps55285-current-limit-accuracy-in-full-range 器件型号…
您好，
If the boost mode current limit set in REG0A response time is too slow to prevent the battery voltage from dropping then there is not much which can be done from the perspective of the charger IC.
Also section 9.2.14.2.1 on page 31 of the datasheet…
您好，请参考下面内容：
you can set the device to recover solely with a charge current. You will have to enable SCDL (Settings:Protection:Enabled Protections C:[SCDL]) and set SCDL limit (Protections:SCDL:Latch Limit) to 1, so that it triggers after a single SCD…
Other Parts Discussed in Thread: TPS628502-Q1 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1459705/tps628502-q1-the-more-information-on-current-limit…
