请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 /*--------------------------DC Current Limit Code Snippet depend on SpeedRPM--------------------------*/
if (DC_Bara_Current_value_mA > DC_BARA_Current_max_limit)
{
if (limitHizAtamaSwitch…
Current peaks through the internal bootstrap diode are expected during two main conditions. The first of those being startup when the first LO pulses occur to charge the bootstrap capacitor. The second being a smaller pulse during steady state conditions…
Part Number: TPS1685
Hi TI partner, I am an ASUS engineer.
My project found TPS16851 OCP limit point is 6.262A, SCP limit point is 2.739A, OCP current setting is 6A, SCP is IOCP*1.5, the test results do not match our design, please help us solve it. TPS1685_CALC_v2_FAN_0…
Part Number: TPS1HTC30-Q1 Hi,
I'm testing this smart high-side switch.
This IC max current is 6A.
Vs pin = 24~26V
EN = 5V
ILIM = 24Kohm to GND.
Theoretically the current limit should be 4.16A
when I put the load on the Vout, setting the current over…
Thank you for your reply, I added some experiments again. and I have some more information to offer you.
I feel like the situation is a little bit like the pulse-by-pulse Current Limit.
The following figure shows the comparison of GHX-GND and PWM waveform…
We do not support RTOS based display on AM62x either from M4 or R5 core. There are some experimental (limited support on these examples) examples on AM62x A53 core with freeRTOS, that too with no support/example for display sharing among different cores…
Hello，
A similar ticket with your issue, please refer to
TUSB320: HOW TO SET WITH TUSB320 TO LIMIT CURRENT - Interface forum - Interface - TI E2E support forums
