Other Parts Discussed in Thread: TPS25763-Q1 , TPS25772-Q1 请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1573250/tps25763q1evm-request-assistance-for…
Part Number: LM3478Q-Q1 Other Parts Discussed in Thread: LM3478
when power supply increased from 0V to 5V and MOSFET controlled as open,we found the frequency in DR pin is change,but finally DR pin will driver to high for a long time.
Question from my…
Part Number: LDC1612-Q1 Other Parts Discussed in Thread: LDC1612
Hi Ti Team
Recently, I have been using the LDC1612 to measure data from different metals approaching the sensing coil axially. As shown in the diagram, the results obtained are reasonable…
Part Number: TDA4VH-Q1
May I ask what the requirement for equal-length traces in the PCB routing design of the LPDDR4 interface for the TDA4VH chip is? Does the equal length limit of PCB traces need to take into account the internal pin delay of the chip…
Part Number: DS90UB936-Q1
你好,我的芯片搭配的poc线路在测试的时候使用频段的某一50MHZ带宽内的回波损耗出现了一个-20dB的向下的尖峰,尖峰位置相位频率曲线的斜率基本保持一定值、群延时也在1nS范围内波动;同一频谱位置插损升高0.1dB左右;理论上来说这种显示信号传输过程中这一频段的反射更少了,匹配更优了?想咨询下在解析的时候是否会影响接收信号的稳定性,提高误码率?