Part Number: UCD3138HSFBEVM-029 在导入一个从贵司网站下载的UCD3138HSFBEVM-029工程后,编译一直无法通过。
一直提示有两个error :
Error1: Program "make" not found in PATH
ERROR2: This project was created using a version of compiler that is not currently installed - 5.2.4 [Arm]…
Part Number: UCD3138A Other Parts Discussed in Thread: UCD3138HSFBEVM-029 目前想Fusion Digital Power Studio提供的功能来对电源的保护点进行在线更改并存储到FLASH中,使用的是UCD3138HSFBEVM-029提供的例程,但发现在线更改的值无法保存到FLASH中,掉电复位后仍然会还原。具体操作是将1处红框75改为85,然后点击红框2处write to hardware将更改值写入RAM,最后点击红框3将RAM的值存入FLASH…
Other Parts Discussed in Thread: UCD3138HSFBEVM-029 请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/969041/ucd3138hsfbevm-029-ucd3138hsfbevm-029-transformer…
Other Parts Discussed in Thread: UCD3138HSFBEVM-029 If the evaluation board is not connected to the electronic load, Does it have an output?(My board is UCD3138HSFBEVM-029)
Due to the laboratory equipment, I provided the board with a 36V current limiting point of 1A, but the board has no output, and the D13LED light is not on. I want to ask if the reason is that the input power supply current is too small.
(My board is UCD3138HSFBEVM…
Other Parts Discussed in Thread: UCD3138HSFBEVM-029 , UCD3138 购买了UCD3138HSFBEVM-029评估板,使用 TI Fusion Digital Power Designer软件,通过 USB-TO-GPIO接口与UCD3138HSFBEVM-029评估板连接,一切正常。
在调试软件时,由于软件一个参数设置不正确,评估板上Mosfet管Q_T1、Q_T2、Q_B1、Q_B2烧坏,购买Mosfet管并替换坏的,评估板别的部分电路正常。
…