E2E™ 设计支持
E2E™ 设计支持
  • 用户
  • 站点
  • 搜索
  • 用户
  • E2E™ 中文设计支持 >
  • 论坛
    • 放大器
    • API 解答
    • 音频
    • 时钟和计时
    • 数据转换器
    • DLP® 产品
    • 接口
    • 隔离
    • 逻辑
    • 微控制器
    • 电机驱动器
    • 处理器
    • 电源管理
    • 射频与微波
    • 传感器
    • 站点支持
    • 开关与多路复用器
    • 工具
    • 无线连接
    • 参考译文
    • 存档组
    • 存档论坛
  • 技术文章
    • 模拟
    • 汽车
    • DLP® 技术
    • 嵌入式处理
    • 工业
    • 电源管理
  • TI 培训
  • 快速入门
  • English
  • 更多
  • 取消


搜索提示
找到 6,627 个结果 查看 问题 帖子 排序依据
  • RE: LM3410-Q1:Schematic Review and Technical Issue Discussion

    cheng zhang
    cheng zhang
    We are currently working on a SPEIC circuit, but there are issues with the design. We plan to replace D33 with an inductor. Could you recommend the inductance value? Should both the inductance and current rating be the same as L7? Currently, L7 is 2.2uH…
    • 2 个月前
    • 电源管理
    • 电源管理论坛
  • TPS23881: 电源管理论坛

    Winston Chen
    Winston Chen
    TI 认为已经解决
    Part Number: TPS23881 Hi Sir I want to design a PSE circuit with a power of more than 45W. A few questions below. 1. TPS23881 does not support autonomous mode, so does the design require an external MCU? 2. TPS23881 supports at, af and bt, so it is compatible…
    • 4 个月前
    • 电源管理
    • 电源管理论坛
  • Answered
  • [参考译文] TPS543A22:尝试重新创建 Webench 电路时出现网络列表错误

    admin
    admin
    已解决
    Other Parts Discussed in Thread: TPS543A22 , TPS543B22 请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/tools/simulation-hardware-system-design-tools-group/sim-hw-system-design/f/simulation-hardware-system-design-tools…
    • 已回答
    • 1 年多前
    • 仿真、硬件和系统设计工具(参考译文帖)
    • 仿真、硬件和系统设计工具(参考译文帖)(Read Only)
  • RE: LMX2491: A voltage ramp waveform is generated through LMX2491 to control the external VCO

    Taylor
    Taylor
    Hi, The GUI configuration is ok but the amplifier circuit is not correct. PLL Sim ( www.ti.com/.../PLLATINUMSIM-SW) to design the loop filter. TRIG2 is not needed.
    • 8 天前
    • 时钟和时序
    • 时钟和计时论坛
  • Answered
  • [参考译文] UCC28950:由 WEBENCH 电路仿真的 UCC28950 PSFB 设计无输出

    admin
    admin
    已解决
    Other Parts Discussed in Thread: UCC28950 , TINA-TI 请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1515017/ucc28950-no-output-from-ucc28950-psfb-design…
    • 已回答
    • 5 个月前
    • 电源管理(参考译文帖)
    • 电源管理(参考译文帖)(Read Only)
  • RE: PMP41009: 电路设计

    cks Chen
    cks Chen
    Hello, I have another question. The chip I selected for the flyback circuit I designed has a built-in high-voltage startup circuit, so there is no need for an external high-voltage startup circuit to provide the initial voltage. The MOSFET I use is a…
    • 2 个月前
    • 电源管理
    • 电源管理论坛
  • LMH13000RQEEVM: LMH13000RQEEVM RSET

    阿德 陳
    阿德 陳
    Part Number: LMH13000RQEEVM Other Parts Discussed in Thread: LMH13000 Hello,According to the suggestion:"datasheet 19 page “The VSET voltage is applied using a DAC through a 20kΩ series resistor." As shown below test circuit : Correction…
    • 29 天前
    • 放大器
    • 放大器论坛
  • RE: CDCLVD1204: no output

    dao xia
    dao xia
    The URL of the image is as follows. D2 also no output .So where are these two circuit designs designed incorrectly https://img.picui.cn/free/2025/06/23/685953e07e41e.jpg
    • 4 个月前
    • 时钟和时序
    • 时钟和计时论坛
  • RE: UCC28070: 关于采样问题

    FRANK1
    FRANK1
    I think in place of R71, R63 and C144, you can keep a small rc filter mentioned as Rfa/Rfb and Cfa/Cfb in the datasheet, which are used to mitigate any unwanted noise seen by the CSA/CSB pin. You can take a look at the current sense transformer equivalent…
    • 2 个月前
    • 电源管理
    • 电源管理论坛
  • Answered
  • [参考译文] WEBENCH-POWER-DESIGNER:Webench 电源设计仿真器

    admin
    admin
    已解决
    Other Parts Discussed in Thread: LM5190 请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/tools/simulation-hardware-system-design-tools-group/sim-hw-system-design/f/simulation-hardware-system-design-tools-forum/1468599…
    • 已回答
    • 9 个月前
    • 仿真、硬件和系统设计工具(参考译文帖)
    • 仿真、硬件和系统设计工具(参考译文帖)(Read Only)
<>

未找到您搜索的内容?发布一个新问题吧。

  • 发布新问题