您好
TI有过澄清，可以看下方链接。
Both the diode and the BOOT capacitor need to be connected to the SW node. The Webench schematic is correct.
e2e.ti.com/.../lmr14010a-about-circuit-design-using-lmr14010a
Other Parts Discussed in Thread: TL431 , TINA-TI 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1603319/ucc28c50-q1-soft-start-circuit-and-ssr 器件型号： …
If you calculate that the temperature of the chip exceeds the junction temperature, it may be a design issue.
You can use webench to redesign your circuit
www.ti.com/.../LM5160A
If the temperature still exceeds the standard, it is recommended to use…
Other Parts Discussed in Thread: WEBENCH-POWER-DESIGNER , TINA-TI 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/tools/simulation-hardware-system-design-tools-group/sim-hw-system-design/f/simulation-hardware-system…
Part Number: TPSM33615
Currently, we need to design a power conversion circuit with an input of 28V and an output of 12V. However, when using the calculator for design calculations, the absence of a model option corresponding to the 12V output has led…
Part Number: RC4558
We currently use the circuit shown in the figure below for front-end amplification. Connector J1 is connected to the microphone, and IN1_P / IN1_N go to the rear-end ADC.
During recording, there is no sound output; only…
