Replacing the NTC resistor did not work, as the circuit board still activates overcurrent protection the moment the relay closes. When I set the relay to never close, the voltage can be boosted, but this clearly deviates from the original design intent…
Hi，
I noticed that you have already posted on E2E inquiring about this issue. Christian is waiting for your update. Please update the original post. The link to your post is as follows, e2e.ti.com/.../bq24610-circuit-design-verification
Thank you for your reply, but the actual situation is a little different from what you described, we see that D4 and D5 have completed full-wave rectification before D6, D6 does not play the significance of rectification, through simulation we can find…
Other Parts Discussed in Thread: UCC28950 , TINA-TI 请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。 https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1513505/ucc28950-no-output-from-ucc28950-psfb-design…
Part Number: XTR116 Other Parts Discussed in Thread: XTR117
I want to design a 2-wire detector,the signal output by the detector is a high-speed pulse signal,the width of the output signal is 1us.Can i use the XTR116 for the 2-wire detector interface circuit…
Hello, I have updated the register. Here are the waveforms of BCLK and FSYNC that I captured with the oscilloscope, along with my ADC5140 peripheral circuit diagram. Are there any errors in my ADC5140 peripheral circuit design? Thank you.
