TI工程师
您好!
目前在用PGA309开发一款压力变送器,采用四线校准可以校准,但是如果直接采用三线校准就不可以校准,必须要先通过四线校准一次,然后才可以采用三线校准,就是一块新的PCB如果直接用三线校准给电桥供电的EXT没有电压出来,请问这是什么原因了,要做什么样的处理了!
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
TI工程师
您好!
目前在用PGA309开发一款压力变送器,采用四线校准可以校准,但是如果直接采用三线校准就不可以校准,必须要先通过四线校准一次,然后才可以采用三线校准,就是一块新的PCB如果直接用三线校准给电桥供电的EXT没有电压出来,请问这是什么原因了,要做什么样的处理了!