CHEM ID选择时，放电电流大小

实际操作中都用的0.2C,0.1C放电周期太长。

建议还是按照0.1C来做。

你好，非常感谢您的答复。

我目前上传LOG后，未获取到匹配的CHEM ID，麻烦帮我看下LOG 的告警

 Warning: First OCVpoint has non-zero current I=  -0.064 Please make sure you have a 2 hr relaxation period before the beginning of discharge.

Warning: Last OCVpoint has non-zero current I=  -0.064 Please make sure you have a 5 hr relaxation period after the end of discharge.

Warning: difference between initial and final DOD is less than 90% dDOD_%=  71 Try to decrease the discharge rate

Warning: difference between initial and final DOD is less than 90% dDOD_%=  71 Try to decrease the discharge rate

* Warning: All IDs disqualified because of too high resistance deviation. No suitable ID selection available

另静置时，我板子是有耗电的，这块是否会有影响；

其次我是按照0.2C来放电

你好,非常感谢您的回复,我目前又重新做了一次充放电过程.

芯片：bq34z100，电池:12V 12Ah的铅酸电池，按照充电，静置，放电（外接10欧的电阻放电，放电到6.5V），静置过程。上传LOG后，报警如下，相关LOG和上传文件见附件。请帮忙看下，非常感谢。

Best chemical ID : 437 Best chemical ID max. deviation, % : 29.35

Accuracy Error: Deviation is so high that it is most likely due to anomaly in the data. Please check that data files have recomended format, units and test schedule