ADS1120: ADS1120 电源上电300ms后才进行寄存器配置，请问一下复位命令0X06还是否必须要下发？

就是说规格书里面推荐的配置流程中，复位命令环节是非必要的？

Set CS to the device low;Delay for a minimum of td(CSSC);

Send the RESET command (06h) to make sure the device is properly reset after power-up;Delay for a minimum of 50 µs + 32 · t(CLK);

Write the respective register configuration with the WREG command (43h, 08h, 04h, 10h, and 00h);

As an optional sanity check, read back all configuration registers with the RREG command (23h);

Send the START/SYNC command (08h) to start converting in continuous conversion mode;

Delay for a minimum of td(SCCS);Clear CS to high (resets the serial interface);