请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。
器件型号:DRV8860 您好,
1.请检查附件的原理图设计是否合理?
2.两个 DRV8860未连接到负载。 为什么 FAULT 引脚未下拉?
如何测试开路保护功能?
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
您好!
您在 nFAULT 引脚上需要一个上拉电阻器。 它是开漏输出。 建议使用10K 电阻器。
见8.3.3.2
对于您的原理图、我将切换 J4 (手动阀)并查看 U10上是否检测到 OLD。 或断开 OUT4上的负载。
以下是另一篇有关同时使用2个 DRV8860的 E2E 文章: https://e2e.ti.com/support/motor-drivers-group/motor-drivers/f/motor-drivers-forum/882856/drv8860-drv8860-ol-fault 看起来您是正确以菊花链方式连接它们的。
此致、
Jacob