This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

[参考译文] TPS63070:2层电路板上的建议布局

Guru**** 2527240 points


请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。

https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1304053/tps63070-recommended-layout-on-2-layer-boards

器件型号:TPS63070

我希望您  能够看一看以下布局。 我试图将数据表的建议应用于电源和信号位于顶部、接地位于底部的2层电路板。
附加限制是我无法在焊盘中添加通孔。

以下是我的解释、您能告诉我可能错过了标记的任何地方吗?

谢谢。

我的解释:



为了便于参阅数据表、建议采用以下布局:



  • 请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。

    尊敬的 Robert:

    我想说您的布局很好。 唯一的建议是在 R2的引脚 GND 处添加更多过孔。 尽管 DS 中的参考布局也只有一个。

    此致

    陶氏