TMS320F280039C: Some questions about the FSI handshake

Prodigy 10 points

Part Number: TMS320F280039C

Hello,I have some questions about FSI ：

Is it necessary to go through a handshake procedure before the master and slave devices communicate officially?

Is it possible to have master-slave communication directly without going through the handshake procedure?

Or can communication between the master and slave be achieved by sending only flush frames without sending Ping frames?

Thanks.

2 个月前

0 Eirwen 2 个月前

TI__Mastermind 35945 points

您好，已经收到了您的案例，调查需要些时间，感谢您的耐心等待。

0 Eirwen 2 个月前回复 Eirwen

TI__Mastermind 35945 points

While technically, there is no hardware requirement of handshaking, once the FSITX and FSIRX modules of all devices have been configured, the handshake mechanism should be implemented to prepare each device in the chain before actual data transmission, since devices may power up in an arbitrary order in a real scenario. More information here regarding Using the Fast Serial Interface (FSI) With Multiple Devices in an Application.

It may be possible to only send the flush sequence, but this wouldn't guarantee that the lead and node are properly recognizing each other within the topology. You may give it a try and report back with any specific questions.

C2000 微控制器

C2000™︎ 微控制器论坛

TMS320F280039C: Some questions about the FSI handshake