28335ADCINT中断是怎么触发的？

C:\ti\controlSUITE\device_support\f2833x\v141\doc这里面的4.4说明太少了，您有没有详细一点的说明？4.4这个例程是什么触发的ADC中断？

This ADC example uses ePWM1 to generate a periodic ADC SOC on SEQ1. Two channels are converted, ADCINA3 and ADCINA2.

该例程使用的是ePWM1来触发ADC中断

在TRM内 7.3.1 Input Trigger Description 描述了触发中断源

www.ti.com.cn/.../sprui07.pdf

具体您可以看一下 e2echina.ti.com/.../128860

您好，EOS转换结束信号是从哪里发过来的？哪一张架构图有EOS？

您可以看一下TRM内的说明（直接搜索EOS）

Once triggered, the sequencer cannot be stopped/halted in mid sequence. The program
must either wait until an end-of-sequence (EOS) or initiate a sequencer reset, which
brings the sequencer immediately back to the idle start state (CONV00 for SEQ1 and
cascaded cases; CONV08 for SEQ2).

以及 Figure 7-12. Flow Chart for Uninterrupted Autosequenced Mode