Hi,
I am trying to make my own MSP430F5529LP, and I change the type B port to type C port which is used to burning program.
The following picture is the schematic diagram of the circuit.
But it is unable to burn program with CCS, the following figure is the error happened when burning program. I want know why this happened, and how to solve this problem.
Thank you.
Best Regards,
JY
Hi,
When this homemade board is plugged into the PC, the device is not displayed in the Device Manager.
However, when I plug it into PC with PUR pressing, the following device will appear in the Device Manager.
I want to know how to change my circuit to make my LP burning program with CCS.
As the above problem is very important, wish for your reply. Thank you!
Best Regard,
JY
