Part Number: AM2434
Does the AM2434 EtherCAT slave controller have an L/A LED control signal output pin?
If yes, which one is it?
If no, where does the L/A LED control signal output come from, and what is the processing logic?
Thank you.
Part Number: AM2434
Does the AM2434 EtherCAT slave controller have an L/A LED control signal output pin?
If yes, which one is it?
If no, where does the L/A LED control signal output come from, and what is the processing logic?
Thank you.
In our EVMs, we are using Ethernet PHY L/A signals.
If you need ESC based control, can implement this using a system GPIO via monitoring below registers. We do not support this via PRU firmware.
