TIDA-00602: MCU Prgarming

lol lol

Part Number: TIDA-00602
Other Parts Discussed in Thread: MSP430G2210

Dear TI support,

I hope your day is well. I was wondering how I can program the MCU on the
TIDA-00602 via arduino IDE. Additionally Which pins on the schematic is used for programming/ power.

Thank you.

Best Regards,

Bob

2 个月前

0 Alice 2 个月前

TI__Mastermind 48140 points

Hello,

MCU MSP430G2210 is used in TIDA-00602.
And "TIDCBC5 — TIDA-00602 Firmware" is released in TI web.
www.ti.com/.../TIDA-00602

I do not think arduino IDE can support MSP430G2210.
Please check "6 Getting Started Firmware " in TIDA-00602 user guide.
"Spy-Bi-Wire (2 wire JTAG)” interface is released in J1.
www.ti.com/.../tiduaz7.pdf

In addtion, there are IDE tools and software programming toollisted in MSP430G2210 product page.
www.ti.com/.../MSP430G2210

0 lol lol 2 个月前

Prodigy 60 points

Hello,

I hope your day is well. I was wondering if you would kindly provide the code used for this project.

Best Regards,
Bob

0 Alice 2 个月前回复 lol lol

TI__Mastermind 48140 points

Hello,

Alice 说：
And "TIDCBC5 — TIDA-00602 Firmware" is released in TI web.
www.ti.com/.../TIDA-00602

CCS project is included.

MCU driver MSP430-SDK Software development kit (SDK) | TI.com

0 lol lol 2 个月前回复 Alice

Prodigy 60 points

where is the CCS project located?

0 lol lol 2 个月前

Prodigy 60 points

Hello,

I was wondering what each pin of the 4 pin jst header is used for in terms of the mcu programming. I am planning on switching it out to a usb_C.

Best Regards,

Bob

0 Alice 2 个月前回复 lol lol

TI__Mastermind 48140 points

Hello,

lol lol 说：
where is the CCS project located?

TIDCBC5 — TIDA-00602 Firmware

lol lol 说：
I was wondering what each pin of the 4 pin jst header is used for in terms of the mcu programming. I am planning on switching it out to a usb_C.

This TI Design supports Spy-Bi-Wire (2 wire JTAG) protocol that is listed in user guide.

Electric Toothbrush Controller Reference Design

电机驱动器

电机驱动器论坛

TIDA-00602: MCU Prgarming