8.average several readings for higher accuracy, poll ManufacturerData() until ZZ increments that indicates updates values.
•ADCCC = [ADCCC(reading n) + … + ADCCC(reading 1)]/n
9.calculate gain value:
•Boardoffset=(ADCCC−CCOffset)/(CoulombCounterOffsetSamples)
10.update Data Flash with Board Offset
11.double check current reading, repeat steps if readings not accurate
12.exit calibration mode by sending 0x002d to ManufacturerAccess() or continue with calibration
(ADCCC−CCOffset) 请问下这里是不是加号 不是减号，谢谢！
